Silicone Seals for Radiation Environments: Evaluating IOTA 3120 Phenyl Vinyl Silicone Gum Silicone rubber is widely used in sealing, insulation and specialty industrial components. However, a......
2026-10-22Low-Temperature Potting Materials Become Too Rigid? Evaluating IOTA 3108 Phenyl Silicone Gum A potting or sealing material may perform well at room temperature but become unsuitable when expo......
2026-10-21Silicone Rubber Swells in Fuel? Evaluating IOTA-R-V2210 Vinyl Fluorosilicone Oil for Liquid Rubber Formulations A silicone rubber component may perform well during initial testing but show un......
2026-10-20Dampers, shock absorbers and precision motion-control equipment may respond differently when operating in cold environments. A system that works normally at room temperature may become slower......
2026-10-19Why Does Silicone Potting Gel Fail to Cure in Certain Areas? Silicone gels are widely considered for electronic encapsulation and other applications where a flexible protective material is re......
2026-10-16Does Higher Silicone Rubber Hardness Mean Better Low-Temperature Sealing? When selecting silicone rubber for industrial seals, buyers often start with hardness. A typical request might ......
2026-10-15Can Ethyl Silicone Oil Be Used Directly as an Electrical Insulating Fluid? Silicone fluids are used in a variety of industrial applications, including lubrication, release and electrical insu......
2026-10-14Does a 320°C Flash Point Mean Silicone Oil Can Operate Continuously at 320°C? When selecting a silicone fluid for high-temperature equipment, buyers often compare the maximum temperatures lis......
2026-10-13Oil Contamination in Vacuum Coating: Is the Diffusion Pump Fluid Always Responsible? Surface cleanliness is important in optical coating and other high-vacuum manufacturing processes. W......
2026-10-12Choosing Fluorosilicone Oil for Industrial Lubrication and Damping: What Should You Check? Industrial lubrication and damping systems require fluids that match the operating conditions of the......
2026-10-10Why Do Molded Rubber Parts Show Oily Residue After Release? A rubber or plastic part can be removed from its mold successfully, yet still show an unwanted oily film on its surface. This......
2026-10-08PVMQ Inquiry: Does the Customer Need Phenyl Silicone Gum or a Ready Compound? A customer asks: “We need phenyl silicone rubber.” That is useful information—but it is not enough to......
2026-09-30When Should Phenyl Silicone Fluid Be Considered for High-Temperature Lubrication? Silicone fluids are widely considered for industrial lubrication, damping and other applications requiring us......
2026-09-29A Seal Becomes Hard at Low Temperature — Is the Seal Design Always the Problem? A seal performs normally at room temperature. But after entering a low-temperature environment, it begins......
2026-09-28Vacuum Performance Is Dropping: Is It Time to Replace the Diffusion Pump Oil? After a vacuum coating or other high-vacuum system has operated for some time, a user may notice: Pump-down......
2026-09-24